Cope And Stick Cabinet Doors Vs Mitered

The stiles and rails in cope stick doors meet at a 90 degree angle using a machining method called coping.

Cope and stick cabinet doors vs mitered.

I had a custom bathroom vanity made and when it was delivered was appalled at how noticeable the mitered joints on the cabinet doors were. This drawing shows the difference between the mitered joint and the cope and stick joint. The more detailed doors are harder on the finisher too. Comments 1 mortis and tenon are much more sustainable also more high end see more.

Mitered vs cope tenon cabinet doors. Shop cope stick cabinet doors at the door stop. The two are similar in that they use 4 frame sections and a center panel but differ in the way the 4 frame sections are joined. Most end up being mitered simply for the look they can t get with cope and stick and the cost of applied molding doors making them an attractive alternative.

Mitered vs cope and stick cabinet doors. No reason why you can t use the stick profile sans cope to produce lots of linear feet of door frame molding followed by outer edge profile. Cope and stick doors differ from the other 5 piece design by the method of joining the frame. You need a stick and cope door in the plain white paint see more.

Would a cope and stick construction be a better choice. Still in certain situations a miter is the better choice. The cabinet is painted white no glaze. The cope and stick joint for cabinet doors is made with a mortise and tenon joint.

Then you just chop off the door frame lengths you need as a miter joint. See the post on what is a mitered cabinet door for more info. Mitered and applied molding tend to be higher end. While cope stick doors are joined at a 90 degree angle mitered doors are assembled by cutting the stiles and rails at a 45 degree angle.

The two main types of framed cabinet door designs are cope and stick and mitered joints. If you want a raised panel no mitered raised panel and no glaze. A cope and stick joint also makes it possible to trim the door after it s assembled you can take a little off of one edge or trim the door slightly out of square to match an out of whack cabinet opening without any noticeable change in the appearance of the door or the joint. You can t profile the outer edge of cope and stick until after assembly.